MakerFocus 1.44 inches TFT LCD Screen Display 128x128 SPI
This lovely little display breakout is the best way to add a small, colorful and bright display to any project.
We've written a full open source graphics library that can draw pixels, lines, rectangles, circles, text and bitmaps as well as example code and a wiring tutorial . The code is written for Arduino.
Note: If you want to show the whole pitcure on the screen, it's suggest using arduino mega2560. Because when you use Arduino UNO, the memory is not enough which cause the application simply ran out of memory.
If you want to show Chinese and English characters, the memory of ordinary Arduino UNO board is enough.
The breakout has the TFT display soldered on (it uses a delicate flex-circuit connector) as well as a ultra-low-dropout 3.3V regulator and a 3/5V level shifter so that you can use it with 3.3V or 5V power and TTL control logic.
Suggest using arduino / 51 / 5V single chip microcomputer because this module is equipped with power and I/O voltage transfer circuit.
128x128 color pixels
Offer Arduino51 SMT32 Routines
The TFT driver is ST7735
SPI interface control
Compatible with arduino port. Plug in then you can run it.
Compatible with 5110 LCD Interface.
Support arduino / 51 / SMT32 etc general single chip microcomputer.
1 * TFT LCD Screen 1.44 inches TFT LCD Module
We Also Recommend
MakerFocus 2Pcs I2C OLED Display Module 0.91 Inch I2C SSD1306 OLED Display Module
MakerFocus Raspberry Pi 7 Inch Capacitive Touch Screen TFT LCD Display for RPI 4B/3B+ Drive-free
MakerFocus 1.5inch I2C OLED Display Module for Arduino/Raspberry/Jetson Nano/STM32
4pcs I2C OLED 0.96 Inch OLED Display Module IIC SSD1306 128 64 LCD White for Arduino UNO R3 STM