4pc 3D Printer Fan 12V 0.1A DC 30mx30mx10mm Double Ball Bearing Mini Quiet Cooling Fan
Note: Voltage range: 7V-12V, Starting voltage: 7V, Working Current: 0.01A. When you use them, pls dont exceed this range!! 2. Any problems, pls click seamuing and choose Ask A Question to email us! We will offer you satisfied solution!
With high performance, long life and low noise. Noise: 25 dBA.
Used for cooling on hot end, 3D Printers, DVR or other cooling needs. 30mm Fan - Size: 30mm x 30 mm x 10 mm ; Cable length: 270 mm. Connector: XH2.54.
Double ball bearing
-Rated voltage: DC 12 V; Voltage range: 7 V-12 V; Starting voltage: 7 V; Starting voltage: 7 V; Rated Current: 0.1 A+5% (When you use them, pls don't exceed this range!!)
-Rated Power Consumption: 1.2 W
-Size: 30 mm x 30 mm x 10 mm
-Cable Length: 270 mm
-Temperature range: -10~80 degrees Celsius
-Speed: 7800Â±5% RPM
-Air Volume Flow: 3.55 CFM
-Noise Level: 25 dBA
-Wind pressure: 3.62mmH2O 0.09INH2O
-Wind speed: 0.1 M /S
With high performance, long life and low noise. Noise Level: 25 dBA
Double Ball Bearing, Lifespan: 5000 hours at 40 degrees Celsius
Used for cooling on hot end, 3D Printers, DVR or other cooling needs
Polarity Protection: Open circuit when Vcc and GND are exchanged; When VCC and GND are connected in reverse, it will not burn the circuit board after being pulled out within 5 seconds
2 pins power connector fan for industrial use.
4 * DC 12V 0.01A 30X30X10mm 3D Printing Fan
We Also Recommend
M5StickC PLUS ESP32-PICO Mini IoT Development Kit
MakerFocus OV2640 Camera Fisheye Extended Version Lens for T-Camera Plus ESP32-DOWDQ6 8MB SPRAM
Lorawan Lora Gateway ESP32 Sx1276 Chip 5V Low-Cost HT-M00 Dual Channel 868-915 MHz Smart Family
MakerFocus 4Pcs 868MHz 2dBi IPEX-1 Connector Spring Antenna New Version for WiFi ESP32 Lora Module