DSTIKE Arduino Bootloader Flash Tool Bootloader Flash Development Tool with Micro-USB for Arduino
It is a bootloader flash tool for Arduino products. It is a bootloader flash tool for Arduino products. If you do not understand what is bootloader I suggest you have a look this:
Bootloader Development: https://www.arduino.cc/en/hacking/bootloader
Arduino as ISP and Arduino Bootloaders: https://www.arduino.cc/en/tutorial/arduinoISP
What makes it special?
It is pre-flashed with Arduino ISP software: https://www.arduino.cc/en/tutorial/arduinoISP
Connect Flash Tool and computer via a Micro-USB cable. Connect Flash Tool to the target board. Indicate LED will turn off for about 10 seconds. Wait until LED turn up . Open Arduino IDE and select the item in the Tools->Board menu that corresponds to the board on which you want to burn the bootloader (Arduino Uno,Nano,Leonardo...). Select Port COMXX(Arduino Leonardo) . Select the Arduino as ISP(Atmega32u4) in the Tools>Programmer menu. Use the Burn Bootloader command. You will see Indicate LED is twinkling when burning process start. Twinkling LED will be off and software says "Finish" at the same time when buring process finish.
1 * DSTIKE Arduino Bootloader Flash Tool
We Also Recommend
MakerFocus GT-U7 GPS Module Compatible with 51 Microcontroller STM32 Arduino UNO R3 and IPEX Antenna
2pcs MAX30102 Heart Rate Sensor Module Heart beat Frequency Tester for Arduino
LoRa GPS Module LoRaWAN 868 915mHz Development Board Antenna for Arduino and Intelligent Scene
MakerFocus WM8960 I2S Expansion Board Amplifier Module with 2pcs Arduino Speaker for Raspberry Pi