MakerFocus 10pcs Arduino NRF24L01+ 2.4GHz Wireless RF Transceiver Module New
The transceiver consists of a fully integrated frequency synthesizer, a power amplifier, a crystal oscillator, a demodulator, modulator and enhanced ShockBurst, protocol engine.
A host microcontroller can communicate and configure the nRF24L01+ over a 4-pin Serial Peripheral Interface (SPI). The configuration registers are accessible through the SPI connection.
Configurable parameters include frequency channel (125 selectable channels), output power, and data rate (data rates: 250kbps, 1Mbps, and 2Mbps).
The module has 5V tolerant inputs which allows for direct connection of SPI pins to the Arduino.
Internal filtering results in high margins of meeting RF regulatory standards.The module #39;s radio uses Gaussian Frequency-Shift Keying (GFSK) modulation as well as fast Automatic Gain Control (AGC)
Ultra small:15x29mm (including:built-in 2.4GHz antenna),for easy implementation into designs without additional hardware
Low power consumption:Ultra low power consumption as low as 11.3mA transmitting, 13.5mA receiving at 2Mbps, 900nA in power down and 26uA in standby
Low operating voltage:1.9 ~ 3.6V When using the nRF24L01 with an Arduino be sure to use the 3.3V output pin from the Arduino board to power the nRF24L01+ module
Communication range:262 feet (80 meters) in ideal conditions
Multi-channel:support six channels data reception
Fast data transfer rate:2Mbps (software setting range: 1Mbps or 2Mbps)
Multi frequency points:125 frequency points to meet the needs of multi point communication and frequency hopping communication
The maximum transmit power:0dBm
10 * Arduino NRF24L01+ 2.4GHz Wireless RF Transceiver Module New
We Also Recommend
LoRa GPS Module LoRaWAN 868 915mHz Development Board Antenna for Arduino and Intelligent Scene
MakerFocus GT-U7 GPS Module Compatible with 51 Microcontroller STM32 Arduino UNO R3 and IPEX Antenna
2pcs MAX30102 Heart Rate Sensor Module Heart beat Frequency Tester for Arduino
MakerFocus WM8960 I2S Expansion Board Amplifier Module with 2pcs Arduino Speaker for Raspberry Pi